Causes of Damage and How to Care the Car Horn

Causes of Damage and How to Care the Car Horn

 

Every car that runs on the highway must be equipped with a horn. The horn’s function is to warn the street user in front of him to give way or care. Traffic accidents often occur due to malfunction of the car horn, or because the horn is not installed. The horn that does not sound can be caused by the contacts that connect the horn with the current source is disconnected and you can see the Auto Window Tint in Fort Lauderdale Florida. Below are some of the problems that often occur on a car horn.

The horn continues to sound

The reason is that an electric current continuously flows into the horn system so that the diaphragm vibrates continuously and creates a sound. This may be caused by an electromagnetic rod from a jammed relay in a sealed position or a hocked horn contact at the sealed position.

The horn does not sound at all

The reason is that the electric current does not flow into the horn system due to fuse breaking, damage to the relays, damage to the breaker contacts or because the cable is broken. Another cause is the electric current from the battery is weak so the magnetism is not strong enough to vibrate the diaphragm or you can visit Car Window Tint in Fort Lauderdale Florida. Incorrect horn settings can also cause the horn not to sound.

Things you can do for improvement

Hit the horn button. Take a good look at the sound. An abnormal sound indicates a horn damage. Explore the honking circuit. Check the state of the cables, may be peeling, breaking or rusting. If the cable is not working properly, replace or repair it immediately. Unloading the horn switch on the steering wheel. Clean the contact parts of rust and dirt. If the contacts are dirty or rusted then the electric current will be hampered so that the horn work becomes disturbed. Remove the horn and unloading unit by removing the bolts. Look at the parts carefully. If you need to put a mark for the link again. Check the state of the contacts from possible wear, dirty, or rust. Wearing contacts should be repaired immediately. The contacts should be clean so as not to inhibit the flow of the flowing current.

Leave a Reply

Related Posts

Begin typing your search term above and press enter to search. Press ESC to cancel.

Back To Top

Causes of Damage and How to Care the Car Horn